About Aluminum Composite panel


The Key Coating Component

KYNAR 500® resin- a flour- polymer with remarkable bonding properties of its molecular structure- the carbon/fluorine bond (one of the strongest bond). Life expectancy of 20 yrs of PVDF coating.

AdhesionThe perfect bonding between the Aluminum coil & core achieved by using adhesive film manufactured from raw material sourced from DUPONT USA.

Specifications

STANDARD DIMENSIONS OF ACP
Width : 1220mm (1550mm optional)
Length : 2440 mm,3050 mm, 3660 mm (up to 6100 mm optional)

2 mm : PE   |   3 mm : PE   |   3 mm : PVDF   |   4 mm : PVDF

A. Width: ± 2.0 mm B. Length : ± 4.0 mm C. Thickness: ± 0.2 mm
D. Bow : ± 0.5% Length or width E. Square ness : Maximum 5.0 mm

THE FOLLOWING TESTS ARE CONDUCTED AT OUR IN-HOUSE TEST CENTRE

Thickness Of ACP Panel Thickness of Paint Coating (PVDF)
Thickness of Aluminum coil Gloss Test
Color Matching in Repeat Orders of Coil Hot Air Oven Test
Salt Spray Test Humidity test for weather ability
Peel Off strength Flexural Strength
Shearing Strength Ball Drop
Acid Test & Solvent Pencil Hardness
Bending Strength of PE board and Panel

  1. Drilling

    Always use drill bits for aluminum sheets and plastic panels. For larger holes use a drill bit with a locating point.

  2. Routing

    Conventional routing equipment can be used. Plastic or wood vice jaws should be used to avoid pressure marks when chucking the work pieces.

  3. Shearing

    Can be done with a guillotine. All blanking tools should be padded to avoid marks.

  4. Bending

    Always use drill bits for aluminum sheets and plastic panels. For larger holes use a drill bit with a locating point.

  5. Screwing

    Conventional stainless steel, wooden, sheet metal or metal screws should be used. For external use, panel expansion should be taken into consideration.

  6. Folding (by routing)

    Can be done manually after routing a V-groove on reverse side with a panel saw with milling attachment or hand-milling cutter.

  7. Edge Smoothing

    Use file with rasp like cut, to file any roughly cut corners.

  8. Pressing

    Use brake press for min. inside radius r = 15 x t (panel thickness).

  9. Punching

    A steel band tool on a punching base should be used for panels of 2 to 3 mm thickness. Or conventional sheet punching machines for any thickness.